Pathio Users

2 Printers Going So Far!

Got my Zaribo MK2 going ok and my QIDI X-Plus running its first couple test prints.

Not too bad so far.


Can’t wait to see the results!

1 Like

I’ll try to remember to post pictures later.

1 Like

First few prints.

Black ones are from the QIDI X-Plus and grey is from my Zaribo MK2.

Both did decent.

On the grey logo I see stringing which I do not get from S3D. I have the same basic settings for temps, speeds, retraction etc. will need to figure this out.

20190307_160309 20190307_160322