Pathio Users

No single wall in Vase mode

In Vase mode there is only a double wall possible.
Furthermore the Vase bottom layer can be set but has no effect.

Hi @rebsam,
Sorry for not getting back to you right away. Would you mind sending along a feedback report with your project? That’ll help us figure out what’s going on.

  1. Just set up your project to show the problems you mentioned above
  2. Click the unhappy face
  3. Select “I want a reply”
  4. Select “Include your models and settings.”
  5. Paste the URL of this discussion so we know it’s you

Thanks! We’ll take a look and see if we can figure out what’s going on.

image

1 Like

My fault. Sorry.
The settings in the group where not equal to the global print settings.